NEWS:
 
TEL:0510-8672267
E-MAIL:watech-cctv@msn.com
Service project

Interior paint

Interior paint

&Nbsp;   interface: brush bonding agent be sure to brush, and brush evenly.
&Nbsp;   fracture: usually kraft paper and white glue stick cracks (but not 100% won't crack).
&Nbsp;   leveling: need leveling uneven wall surface, gypsum, concave difference not exceeding 0.5 divided into good.
&Nbsp;   patch: light walls and insulation wall non-load-bearing walls are needed patches, try to select a good quality wall covering and white LaTeX, if conditional can mesh, crack would be better.
&Nbsp;   PuTTY: selection of high fineness and hard texture of PuTTY is better, you can also add some white LaTeX PuTTY, PuTTY can be improved hardness.
&Nbsp;   Polish: try using a fine Emery paper, soft texture of PuTTY (821) with sandpaper, 400-500, hard texture (such as wall linings, Yi Gua) using 360-400 as well, if the paper is too rough, we will leave a deep trace of sand, paint is coverage. Polishing is completed must be completely cleaned the wall again, so as to avoid too much dust, affected paint adhesion. Male and female difference does not exceed 3 mm.
&Nbsp;   Primer: Primer make sure you brush evenly, ensuring that every part of the wall painting, if walls to eat large amount of paint, primer and best extra point for the right amount of water in order to ensure the paint evenly. Not because it is a primer on drums will be used, and will directly affect the paint primer paint effect effect, used to paint the same drum.
&Nbsp;   make: PuTTY polished finished zhihou, will left some flaws (pit eye), general situation Xia hard see, only brush had a again paint zhihou only will is obviously, then on need make has, note make must to polished flat, again with slightly more one points water of primer brush a again, so as not to brush surface paint of when because and other wall surface of draft volume different and colored poor.
&Nbsp;   surface paint: don't added excess of water, will effect paint film thickness, and feel and paint film of hardness, as select good is of tool, drum of hair don't too short, but must to fine, such brush out of paint film only will feel delicate, brushing main note corner, and each roll Middle answer part and received paint direction, corner of processing, most situation is with brush or scrub brush for brushing, such will easy caused corner texture and whole surface not consistent, Visual Shang will has differences, If has conditions words can buy a put received side drum, corner with scrub brush Shang paint zhihou again with received side drum received a again, note received side drum of material to and brush big surface of drum consistent, brush big surface of when each roll answer place of paint must to received uniform, cannot had thick also cannot had thin, or will because thick not are caused reflective inconsistent, brush paint of when each roll Shang wall zhihou will has a received paint action, this will requirements each roll received paint of direction to consistent, or will caused each roll of roll out of texture inconsistent, reflective angle on will different , There will be differences on the Visual. (Recommendation: buy before painting a tray that will be sold in the shop, rolling tray can be used to ensure that each brush, paint roller is as much, so that brush evenly. ) The conservation: dry finish coat of paint after 4 hours, but dry paint film has not reached a certain degree of hardness, it is nursing, very simple, 7-10 days never have to scrub or any contact with the wall. BACK

© 2017 Wuxi Hi Clean Clean Cleaning Co.,Ltd, All rights reserved.